铝方通的安装方法

2020-05-24

1、根据要求的水平高度拉好水平线，纵横垂直均需拉好；

2、按合适的间距吊装卡齿龙骨，一般间距1-1.2米，吊杆距离按轻钢龙骨的规定分布；

3、把预装在龙骨上吊件，连同方通龙骨装在轻钢龙骨下面，方通龙骨间距一般为1米，全部装完后必须调整至水平；

4、将铝方通、木纹铝方通系列按顺序扣挂在龙骨上，再将倒锁片压下，方通端头应保持10mm或20mm的距离；

5、安装木纹铝方通时必须带手套，如不慎留下指印或污渍，可用洗洁精开水洗后抹干即可。

1, according to the required horizontal height pull the horizontal line, vertical and horizontal vertical need to pull well;

2, according to the appropriate spacing hanging teeth keel, general spacing 1-1 .2 meters, hanging rod distance according to the light steel keel distribution;

3, pre-mounted on the keel hanging parts, even with the square dragon bone mounted on the light steel keel, the square keel spacing is generally 1 meter, after all the installation must be adjusted to the level;

4, aluminum square pass, wood aluminum square pass series in order to hang on the keel, and then press the relock plate, the square end should maintain a distance of 10mm or 20mm;

5, the installation of wood aluminum square must wear gloves, if inadvertently left fingerprints or stains, can be washed with detergent boiling water after drying.